Efek Parameter Feeding dan Kondisi Geometri Cutter terhadap Kekasaran Permukaan Baja ST 60 pada Proses Milling Vertikal

Marianus Beatriks Djala Gili, Darto Darto, Surjedi Surjedi, Agus Iswantoko

Abstract


The milling process is one type of conventional machining process that is often carried out. The surface quality of the workpiece produced in the milling process is influenced by several factors, including the speed of feeding and the condition of the cutter. The aim of this study was to determine the effect of variable feeding and cutter conditions on the surface roughness of steel in conventional milling processes. The research was conducted using an experimental method. The research object is ST 60 steel which is processed on a micron milling machine WF3 SA. The research data shows that the feeding speed affects the surface roughness quality, where the greater the feeding value, the greater the Ra value. In addition, the condition of the cutter also has an effect, where slashing using a new cutter produces a Ra value which tends to be lower than slashing using a sharpened cutter. The lowest Ra value is 0.45 m occurs at 10 mm/minute feeding using a new cutter. While the highest Ra value at 40mm/minute feeding is 1.54 m using a sharpening cutter.
 

Keywords


Milling; feeding; cutter; surface hardness

Full Text:

PDF

References


A. Hasan and G. El-Hofy, Fundamentals of Machining Processes Conventional & Non-Conventional Processes. Boca Raton: CRC Press, 2014.

M. A. Hendrawan, “Studi Pengaruh Parameter Pemotongan Terhadap Kekasaran Permukaan pada Proses Up dan Down Milling dengan Pendekatan Vertikal Milling,” Media Mesin, vol. 11, no. 1, 2010.

M. P. Groover, Fundamentals of Modern Manufacturing: Materials, Processes and Systems, Fourth Edi. USA: John Wiley & Sons, inc., 2010.

A. Kurniawan and A. P. Herda, Teknik Manufaktur Milling Semester 1. Solo: ATMI Press Surakarta, 2008.

T. Rochim, Teori dan Teknologi Proses Pemesinan. Bandung: ITB, 1993.

T. Rochim and S. Handjoko, Spesifikasi Geometris Metrologi Indutsri dan Kontrol Kualitas. Bandung: ITB, 1998.

S. Sumardiyono, Panduan Praktik Gerinda 2. Surakarta: ATMI Press Surakarta, 1998.

W. Widarto, Teknik Pemesinan. Jakarta: Departemen Pendidikan Nasional, 2008.

Y. Yunus and H. Syaifullah, “Analisis Tingkat Kekasaran Permukaan Hasil Proses Milling pada Baja Karbon S45C,” 2012.




DOI: https://doi.org/10.26905/jtmt.v18i1.7561

Refbacks

  • There are currently no refbacks.


TRANSMISI

Universitas Merdeka Malang

Mailing Address:

Jalan Terusan Dieng 62-64 Malang, 65146, East Java, Indonesia
Phone: 081333961913 Fax: (0341) 560836
Email: jm.transmisi@unmer.ac.id